Compatible Genuine Comfort units can operate using either the built-in display panel or an external 24V wall thermostat.
Follow the instructions below to change the control mode on your unit.
Understanding the Control Modes
- P – Panel Mode: The unit is controlled using its built-in display panel.
- r – Remote Mode: The unit is controlled using the connected wall thermostat.
In remote mode, the display panel buttons cannot be used for normal heating, cooling or temperature control.
Video Instructions
GC42 42" and GCDM 32" PTAC
Switching From Display Panel to Wall Thermostat Control
- Turn the unit off using the display panel while keeping it connected to power.
- Press and hold the HEAT and + buttons simultaneously for 3 seconds.
- Confirm that a lowercase r appears on the display.
- The unit can now be operated using the connected wall thermostat.
Switching From Wall Thermostat to Display Panel Control
- Ensure the unit is in standby mode while connected to power.
- Press and hold the HEAT and + buttons simultaneously for 3 seconds.
- Confirm that an uppercase P appears on the display.
- The unit can now be operated using the built-in display panel.
GCTW Through-the-Wall Units
Follow the same procedure described above, but press and hold the MODE and + buttons simultaneously for 3 seconds to switch between panel and remote control.
GC42 Elite and Other Control Configurations
Some models require DIP switch adjustments or a different control mode configuration.
Refer to your exact model's user manual and the applicable articles below before changing any settings.
Always disconnect power before adjusting DIP switches or thermostat wiring.
Additional Resources
- How to Install a Wired or Wireless Thermostat on Your Genuine Comfort PTAC
- How to Control Your GC42E Using a Wired Thermostat or Display Panel
- How to Control Your GC42E Using a Wireless Thermostat
Need Assistance?
Contact technical@genuinecomfort.com with your unit's model number, thermostat model and a photo of the display panel.