Proper installation of your Genuine Comfort GCDM 32" PTAC into the wall sleeve helps prevent air leakage, improves energy efficiency and ensures reliable heating and cooling performance.
Video Instructions
Watch the video below for a demonstration of how to install your GCDM PTAC into the wall sleeve.
Before Installation
- Ensure the wall sleeve is compatible with your GCDM unit.
- Remove all protective shipping materials.
- Verify the wall sleeve pitch according to the applicable installation manual.
- Ensure the unit is disconnected from power.
- Have two people available to safely lift and position the unit.
Step 1: Prepare the Wall Sleeve
- Clean the inside of the wall sleeve and remove any debris or obstructions.
- Inspect existing foam insulation for damage or deterioration.
- Install or replace the adhesive-backed foam insulation to prevent outdoor air from entering the room.
Refer to the GCDM 32" PTAC Wall Sleeve Foam Insulation Kit article for additional information.
Step 2: Insert the PTAC Unit
- Carefully lift and align the PTAC chassis with the wall sleeve opening.
- Slowly slide the unit into the wall sleeve, ensuring it remains correctly aligned.
- Avoid forcing the unit or damaging the foam insulation.
Step 3: Secure the PTAC Unit
- Locate the designated mounting points according to the installation manual.
- Secure the PTAC to the wall sleeve using the appropriate mounting screws.
- Avoid overtightening the screws.
Step 4: Inspect and Seal Air Gaps
- Inspect the installation for gaps around the PTAC and wall sleeve.
- Seal unwanted gaps using suitable insulation, weatherstripping or caulking.
- Ensure drainage and airflow openings remain unobstructed.
- Remove any remaining packaging or installation debris.
Step 5: Test the PTAC Unit
Reconnect power and verify the following:
- The unit powers on correctly.
- Heating and cooling operate as expected.
- Fan speeds and temperature controls function correctly.
- There is no unusual noise or excessive vibration.
Additional Resources
- How to Safely Unpack Your PTAC Unit
- How to Prevent Air Leaks Around Your PTAC Unit and Wall Sleeve
- Recommended PTAC Installation Clearance and Airflow Requirements
Need Assistance?
Contact technical@genuinecomfort.com with your unit's model number, serial number and photos of the installation.