Compatible Genuine Comfort PTAC units can be connected to wired or wireless wall thermostats for room temperature, heating, cooling and fan control.
Thermostat wiring and configuration requirements vary depending on the unit model and thermostat type.
Before Installing Your Thermostat
- Verify that the thermostat is compatible with your unit.
- Turn off and unplug the unit before changing wiring or DIP switch settings.
- Take a photo of the existing wiring connections.
- Refer to the applicable unit and thermostat installation manuals.
Important: Do not allow the R and C wires to touch. This may cause a short circuit, blown fuse or damage to electrical components.
Connecting a Wired Thermostat
- Locate the thermostat terminal block or wiring harness on the unit.
- Identify the corresponding terminals on the wall thermostat.
- Connect the wires according to their terminal functions and the applicable wiring diagram.
- Secure all connections and individually insulate unused wires.
- Configure the unit for wall thermostat control.
Do not rely solely on wire colours when connecting a thermostat.
Connecting a Wireless Thermostat
- Connect the wireless receiver to the unit according to the applicable wiring diagram.
- Install the wall thermostat in a suitable location.
- Supply power to the thermostat according to its installation manual.
- Pair the thermostat with the wireless receiver.
- Configure the unit for wall thermostat control.
Depending on the thermostat model, power may be supplied through batteries or R and C connections.
Thermostat Wiring Diagrams
Select the wiring diagram applicable to your unit.
Always verify that the selected wiring diagram applies to your exact model before connecting the thermostat.
GC42 42" & GCDM 32" PTAC Terminal Blocks
GC---ENR1F-U & GC---ENR1F-E2 Wiring Diagram
GCTW Terminal Block
GC42 Elite Heat Pump (GC42E-H) Wiring Diagram
Enable S3 to ON (UP)
Disable S9 to OFF (Down)
Do not wire Heat 2 to your thermostat as this is a dull wire.
Switching From Display Panel to Wall Thermostat Control
After connecting the thermostat, the unit must be configured for wall thermostat operation.
Depending on the model, this may require changing the control mode through the display panel or adjusting the DIP switches.
Refer to the applicable guide below:
- Changing from Display to Wall Thermostat Control Mode
- How to Control Your GC42E Using a Wired Thermostat or Display Panel
- How to Control Your GC42E Using a Wireless Thermostat
Testing Your Thermostat
After completing the installation, reconnect power and verify:
- Heating and cooling operation, where applicable.
- Fan operation.
- Temperature adjustment.
- Unit response to thermostat commands.
Need Assistance?
Contact technical@genuinecomfort.com with your unit's model number, thermostat model and photos of the wiring connections.